Matching Impedance Is An Important Part Of The PCB

Matching Impedance Is An Important Part Of The PCB

Abstract

Matching Impedance is a characteristic of Radio frequency or microwave design. The impedance equal to 50 ohm is required to effectively transmit the power of the signal from input to destination that is loaded with minimum distortions.

 

If impedance does not match at input and output. There can be a loss of signal, power cannot be transferred to output or distortion may arise, and leads to occurrence of vertical waves. That ratio can approach to infinity.

 

Content

1.Introduce

2.Conclusion

 

1.Introduce

 

But if Matching Impedance is matched. Then the problem of distortion or standing waves cannot occur.Or it can be a low vertical wave fraction in terms of voltage. But it is not easy to maintain impedance equal to 50 om. During transmission of signal from input to output. To uphold the impedance Stripline or microstrip technologies are used.

 

It displays impedance of transmission-line as contrarily relative to the line girth and specifically.Corresponding to the wideness of the dielectric substantial layers.

 

One contrast amongst micro strip and strip line is that. The stature of the flag follow over the ground for Stripline has less of an effect on impedance. It is more effect than the stature of a microstrip flag follow over the ground. The air above a micro strip schematic will actually contribute to the specific impedance. It displays impedance of transmission-line. As contrarily relative to the line girth. And specifically corresponding to the girth of the dielectric substantial layers.

 

Matching Impedance.png

 

If the circuit while a strip line schematic is confined to the interior. That of a sandwich of dielectric material. Air will constantly work to lower the operating dielectric constant of PCB solid . It is used in a micro strip schematic.

 

Due to this condition. The operative dielectric constant of PCB components used in a strip line schematic. Will be greater than the dielectric constituents used in a micro strip schematic.

 

2.Conclusion

 

By the wideness of the metal conduit layer utilized for the transmission lines. The size of the flag shaped on that layer. And the wideness of dielectric substrate. Smith chart is used to acquire an impedance matching.

Do You Have Any Question About PCB And PCBA Manufacturing?

Order or no order, I am always happy to make friends and provide a Free consultant for you.

Any questions about PCB Manufacturing and PCB Assembly Process in your projects, Feel free to consult us online or through email, we will try our best to help you and try to meet your requirements!